Danuser 2312 AugerBucket - Manual (Page 13)

13
Before storage, the Auger Bucket should be thoroughly cleaned per the instructions in the
Clean Up section. Always store the Auger Bucket in a dry location. Do not allow concrete
to dry in the bucket or water to freeze in the bucket. This will cause damage to the rubber
flighting and damage the bucket itself.
STEP 1: Lower the Auger Bucket onto a flat, level surface.
STEP 2: Shut off the vehicle engine, lower the arms, relieve all hydraulic pressure (by
activating the vehicle controls), and remove the vehicle key before leaving the
vehicle seat.
STEP 3: Disconnect the hydraulic hoses from the vehicle’s auxiliary hydraulics.
STEP 4: Follow your vehicle operator’s manual for removing an attachment.
STEP 5: Coat the bucket with a water based releasing agent.
Removal &
Storage
Before disconnecting hydraulic lines or fittings be sure
to relieve all pressure by cycling all hydraulic controls
after shutdown. Remember hydraulic systems are under
pressure whenever the engine is running and may hold
pressure after shutdown.
w A R N i N G
Connect quick couplers together to prevent contaminants from entering the bucket
hydraulic system.
NOTE
C A U T i O N
Do not coat the bucket with a petroleum based cleaning
agent. Damage to rubber components will occur.
w A R N i N G
Personal protection
equipment including
hard hat, safety glasses,
safety shoes, and gloves
are recommended during
assembly, installation,
operation, maintenance,
service, removal, or
movement of the Auger
Bucket.
Never allow anyone under the attachment at any time.
D A N G E R