Danuser 2312 AugerBucket - Manual (Page 11)

11
STEP 1: With the Auger Bucket stationary, add material(s) to the bucket.
STEP 2: Position the vehicle so the discharge chute is directly over the desired location.
Run the auger in the forward direction to discharge the material(s).
Operation
Discharging Auger Bucket
Before you operate the attachment, check over pins and
connections to be sure all are securely in place. Make sure
the Auger Bucket is securely latched to the skid-steer.
Do not attempt to dig with the Auger Bucket. If the optional Scraper Blade is
installed, then scoop from loose piles only.
NOTE
Keep clear of auger while in operation. Never position
the material by hand or with any tool when the auger is
rotating.
Move the vehicle slowly when the attachment is raised, and
carry the load low. A heavy load can cause instability of
the vehicle. Use extreme care during travel. Slow down
on turns and watch out for bumps. Use all safety devices,
including a seat belt, as recommended in the vehicle
operator’s manual.
w A R N i N G
The Auger Bucket is
designed to be operated
from the vehicle seat.
Keep bystanders away
from the work area. Do
not operate with another
person in contact with any
part of the Auger Bucket.
D A N G E R
D A N G E R
D A N G E R
Keep hands, feet, hair, jewelry, and clothing away from all
moving and/or rotating parts.
D A N G E R
w A R N i N G
Personal protection
equipment including
hard hat, safety glasses,
safety shoes, and gloves
are recommended during
assembly, installation,
operation, maintenance,
service, removal, or
movement of the Auger
Bucket.
Never allow anyone under the attachment at any time.
D A N G E R