Brother HL 3070CW User Manual

Page 90

Wireless Configuration for Macintosh using the Brother installer application (For HL-3070CW)

To communicate with the un-configured wireless machine, temporarily change the wireless settings on

your computer to match the machine’s default settings shown on this screen. Check the box after you

confirm these settings, and then click Next.

Note

You can temporarily change the wireless settings on your computer, following the steps below:

1) Click the AirPort status icon and choose Open Internet Connect....
2) Click the Network tab to see the available wireless devices. You can see the Brother wireless print

server in the Network option. Choose SETUP.

3) Your wireless network is connected successfully.

Choose the machine you wish to configure, and click Next. If the list is blank, check if the machine is

powered on, and then click Refresh.

Note

• The default node name is “BRWxxxxxxxxxxxx”.
• You can find your printer’s MAC Address (Ethernet Address) and the IP Address by printing out the

Network Configuration page. See Printing the Network Configuration page on page 123.