Brother HL 3070CW - Manual (Page 193)

Troubleshooting
183
15
Wireless network troubleshooting (For HL-3070CW)
15
Note
If you want to confirm the wireless network status, see b on page 178.
Wireless setup problems
15
The Brother print server is not found during setup by the Wireless Device Setup Wizard.
15
a Make sure that the machine is powered on, is on-line and ready to print.
b Move your Brother machine closer to your access point/router (or your computer for Ad-hoc) and try
again.
c Reset the print server back to its factory default settings and try the wireless setup again (see Reset the
network settings to the factory default on page 122).
Why do I have to change my machine’s network setting to “Wired LAN” during setup although I am
trying to setup Wireless LAN?
15
If you are using Windows ® 2000 / Mac OS X 10.3.9 or greater, your computer is connected to the wireless
network using a network cable, it is recommended you temporarily connect the machine to your access
point/router, hub or router using a network cable. You will also need to change your machine’s network setting
to wired LAN temporarily. Your machine’s network setting will be changed to wireless LAN automatically
during the course of the setup.
„ For Windows
®
:
Configuration in Infrastructure mode on page 29
Configuration in Infrastructure mode using SES/WPS or AOSS from the control panel menu (without
network cable) on page 40
Configuration in Ad-hoc mode on page 46
„ For Macintosh:
Configuration in Infrastructure mode on page 60
Configuration in Infrastructure mode using SES/WPS or AOSS from the control panel menu (without
network cable) on page 70
Configuration in Ad-hoc mode on page 76