Programming – Carbolite 302P4 User Manual
Page 14
Programming
14
MC22 -GB-v1.01
4.5
Programming
Note: the normal 10 seconds timeout is removed while editing the program list.
Program Number
Press function
to show nPrG lower display and the program number in the upper display.
Press the Up
or Down
to choose the program number.
Press
to enter the selected program number.
Password Protection program 1,2,3
After confirming selection of program 1,2 or 3, the word pass will be shown on the bottom
display and ---- on the top display. This will time out after 10 seconds, during this period the
password should be selected using the Up
or Down
Press
to confirm password and enter selected program.
When the correct password has been entered the upper display will flash PASS. If an
incorrect password is entered the upper display will flash Err and then return to the home
display.
Initial Set Point
After confirming password for program 1,2,3 or selecting program 4, the display will then
show, itSP lower display and the value in the upper display.
Use the Up
or Down
to select the initial set point.
NOTE: It is recommended that this value is set to “off” for the controller to display “rdy” in
the home menu (see section 3.1) If a value is assigned, the display will show this value in
place of “rdy”.
Press
to confirm.
Set Point 1
After confirming selection, the display will then show, SP.1 lower display and the value in the
upper display.
Use the Up
or Down
to select set point 1.
Press
to confirm.
Ramp Rate
After confirming selection, the display will then show, rr.1 lower display and the value in the
upper display.
Use the Up
or Down
to select a value for ramp rate.
Press
to confirm