Carbolite 302P4 - Manual (Page 13)

Programming
13 MC22-GB-V1.00
rpt
Meaning:
number of program repetitions of the selected program
Range: - from 0 to 9999 and then inF
The figure expresses the repetitions after the first execution.
For example, if 2 is selected, the program will be executed 3 times, while
inF means that the device is set for endless repetitions.
Available: always
Alterable: only when the programmer state is idle and, for program 1-2-3, the edit is
enabled
Cet
Meaning:
cycle end temperature
Range:
OFF, and then from 0°C (low scale range value) to 1530°C (high scale range
value)
Available: always
Alterable: only, in “Program Edit” mode, when the programmer state is idle or, for
program
1-2-3, if the edit is enabled
”
Note: See "Program End Feature" for operation description
4.3 Creating a program
Programs are created in the programming level “OP.P”. There are 4 programs available.
Programs 1, 2, 3 are protected by security code = 6. Program 4 has no password
protection.
Each of the 4 programs contains 4 ramp/dwell pairs.
4.4 Enter Program Edit level
Press and hold the Function and run keys

simultaneously for more than 3 seconds.
The display will show OPr lower display and OP.b upper display (Op.b being the current
active mode)
Press the Up

or Down

to choose OP.P
Press

to enter selected level.
The word pass will be shown on the bottom display and ---- on the top display. This will time
out after 10 seconds, during this period the password should be selected using the Up

or
Down

Press

to enter the password.
When the correct password has been entered the upper display will flash PASS. If an
incorrect password is entered the upper display will flash Errand then return to the home
display.