Carbolite HRF (MF05) User Manual
Page 10
HRF
10
MF05 – 3.25
5.8 Fuse Replacement
Fuses are marked on the circuit diagram (section 7.0) with type codes, e.g. F1, F2. A list of the
correct fuses is given in section 8.1.
If any fuse has failed, it is advisable for an electrician to check the internal circuits.
Replace any failed fuses with the correct type. For safety reasons do not fit larger capacity fuses
without first consulting Carbolite.
The fuses are near the cable entry point, and access is by removal of the back panel.
See also other documents in the category Carbolite Kiln:
- Peak Series (16 pages)
- AX30 (12 pages)
- GP Series (16 pages)
- GPC Series (16 pages)
- LHT Series (16 pages)
- HRF 7/45 (12 pages)
- ABA 7/35B (72 pages)
- TLD Series (12 pages)
- CR Series (16 pages)
- MTT 12/38/850 (16 pages)
- CF 15 - CF 60 (20 pages)
- PTC 12/20/150 (16 pages)
- CFM Series (16 pages)
- AAF Series (16 pages)
- SNF Series (12 pages)
- HZS Series (16 pages)
- Work Tube End Seals (12 pages)
- MTF Series (16 pages)
- TZF Series (16 pages)
- GHA Series (24 pages)
- TZF Series (16 pages)
- STF Series (20 pages)
- EHA Series (28 pages)
- CWF Series (16 pages)
- ABF 8/28 (16 pages)
- VCF Series (16 pages)
- ELF Series (16 pages)
- HTR 11/75 (16 pages)
- HST Series (16 pages)
- STF Series (20 pages)
- VST 17/-- (16 pages)
- BLF 17/3 (16 pages)
- RHF Series (17 pages)
- HTF 17 (20 pages)
- RHF Series 3 litre - 35 litre (16 pages)
- CDF 15/1b (16 pages)
- CAF 16/38 (16 pages)
- CAF DIGITAL IMAGING (52 pages)