Bear Archery Compound Bow 2004 - Manual (Page 36)

STRING REPLACEMENT
Replacing the string — Single cam systems (continued)
4) Wrap the string over the top and around the out-
ermost groove on the opposite side of the cam.
Attach the end loop to the post.
5) Make sure the string and cable are firmly seated
in the proper grooves as you slowly release the
bow press.
Replacing the string — Teardrop systems
Foot method – It is possible to change the string without
using a bow press on bows equipped with teardrop style
string attachments
only.
Use the following procedure:
1) Back off the limb bolts 2-3 turns (counter clock-
wise).
2) Holding bow in one hand, step on the string.
3) Lift bow up, flexing the limbs.
4) Place the new string on the empty sides of the
teardrop fittings. Lower the bow. Both strings are
now strung on the bow.
5) Make sure the new
string is well-seated
in the teardrop
grooves. Carefully,
step on the
new
string and lift bow,
again flexing the
limbs.
6) Remove the old
string from teardrops.
Lower the bow with
new string in place.
36