Bear Archery Compound Bow 2004 - Manual (Page 27)

ADJUSTING DRAW LENGTH
Vortec Cam
The Vortec Cams are equipped with a multi draw fea-
ture. Draw length changes are made by repositioning the
string spool located on the draw string side of the camp.
Prior to changing draw length, back limb bolts off 2
full turns. To change draw length, it is first necessary to
remove tension from the harness system of the bow by
relaxing the bow in a bow press.
A bow press must be
used. Under no circumstances can this relaxing of the
harness system be accomplished by simply backing out
limb bolts.
With the bow relaxed, the bowstring spool can then
be repositioned to the desired string setting. The #1 posi-
tion (see diagram) lengthens the draw length. The #5
position shortens the draw length.
The longer adjusted draw length setting will increase
bow weight. A shorter adjusted draw setting will decrease
bow weight.
Before removing bow from bow press, make sure all
strings and cables are properly seated and attached to
the cam. Remember to tighten limb bolts once the proce-
dure is completed.
27