BASELINE Lift BL211CF User Manual
Page 3
3
Your new lift will provide years of dependable service if installed, operated and maintained
properly. Read and follow all safety, installation, operation, and maintenance instructions in this
manual before installing and operating the lift. In addition, read and follow all safety and other
information included on and with the lift before operating the lift. Keep this manual in a secure
place for future reference, training and service part identification.
TABLE of CONTENTS
Safety Instructions……………………………………………………………………………….……………………...5
General Requirement and Lift Specifications ....................................................................... 7
Bay Dimension Requirement ........ .....................................................................................8
Pre-Installation Procedures and Tools Required .................................................................. 9
IMPORTANT:
It is the shop owner's responsibility to provide a satisfactory installation area
for the lift. Lifts should only be installed indoors on level concrete floors with a minimum of 4
inches (102mm) and 3000 psi (20.7MPa) concrete that has been aged a minimum of 30 days.
Please consult a qualified individual if any doubt exists concerning proper installation and
subsequent safe operation of the lift. Do not install the lift on asphalt or outdoors.
Prior to installation, it is the shop owner's responsibility to provide constant electrical power in
the correct voltage, phase, etc., and all wiring for electrical hook-up of the lift. The shop owner
must insure that the electrical installation conforms to local building and safety codes. Where
required, the shop owner will provide an electrical isolation switch located in close proximity to
the lift. This switch will have an emergency stop capability and isolate electrical power from
the lift for servicing requirements.
Hydraulic oil cannot be shipped with the lift and will be supplied by either the shop owner or
the installer. ISO 32 hydraulic oil (10W non detergent hydraulic oil) must be used to fill the
reservoir tank before operating the lift.
It is the shop owner's responsibility to train all operators in
lift operation and safety.