Autoquip SUPER TITAN DOUBLE LONG - Manual (Page 8)

8
2.1.2 TSL
Model
Number
Lift
Capacity
(lbs)
Axle Load
Capacity
Over
Bridge
End (lbs)
Axle
Load
Capacity
Opposite
Bridge
End (lbs)
Axle
Load
Capacity
Over
Sides
(lbs)
Platform
Size
(in)
Base
Frame
Size
(in)
Min.
Lowered
Height
(in)
Stand.
Speed
(fpm)
App
Ship
Wt.
(lbs)
TSL- 2 14,000 10,500 9,400 8,700 72 x 120 62 x 118 15.5 9 7,500
TSL- 4 20,000 16,700 15,600 14,200 72 x 120 62 x 118 21.5 8 8,650
TSL- 10 13,000 10,200 9,500 8,000 96 x 120 74 x 118 15.5 9 8,250
TSL- 12 20,000 16,500 15,000 13,200 96 x 120 74 x 118 21.5 8 9,150
TSL- 26 13,000 9,500 8,600 8,600 72 x 144 62 x 118 15.5 9 7,800
TSL- 28 20,000 15,500 14,200 14,300 72 x 144 62 x 118 21.5 8 8,650
TSL- 34 12,500 9,000 8,300 8,000 96 x 144 74 x 118 15.5 9 8,800
TSL- 36 20,000 15,000 13,800 13,100 96 x 144 74 x 118 21.5 8 9,700
NOTE: All TSL models have a travel of 60”, have 2 rams, and have a standard remote 5 HP (230/60/3)
motor.
2.2 Lift Specifications
There are many custom designs whose specifications may vary from those published for standard
models. Please consult the specific General Arrangement (GA) Drawing to obtain the specifications for
application-specific designs.
2.3 Load Capacity
Load capacity rating is stamped on a metal nameplate attached to lift. This figure is a net capacity rating
for a lift furnished with a standard platform. If optional items are installed on lift after leaving
manufacturer, deduct weight of these from load rating to obtain net capacity.
Do not exceed rated capacity of lift. Loading lift beyond its rated capacity is unsafe, will shorten
operational life of lift, and will void warranty.
2.4 Unbalanced Loading
The stabilization provided is basically for balanced loads. If special attachments extend beyond the
length and/or width dimensions of platform, end and/or side load capacity is reduced 2% for each one-
inch extension from center. If load is rolling onto platform (in any but fully-lowered position) end and/or
side load capacity is reduced by dividing the rated end/side load by 1.50 to establish an available “axle”
load.
2.5 Pump Pressure
This lift incorporates a unique, positive displacement pump. Therefore, standard factory models of same
manufacture cannot replace it.