Aquascape AquaBlox (29492) - Manual (Page 3)

3
AquaBlox ® Assembly Instructions
A
A
A
B
8”
Small Matrix consists of 8 panels: 2 “A”, 2 “C” and
4 “D” (see chart below for dimensions)
Panel D
Panel A
Large Matrix consists of 8 panels: 4 “A” and
4 “B” (see chart below for dimensions)
Small AquaBlox ®
The Small AquaBlox ® is recommended in use with
Pondless ® Waterfalls using the MicroSnorkel ™ and
MicroCentipede ™ and also when constructing an
upflow Wetland using the Large Snorkel ™ and
Centipede ™ .
Large AquaBlox ®
The Large AquaBlox ® is recommended in use with
Pondless ® Waterfalls and RainXchange ® System
using the Large Snorkel ™ and ½ or full Centipede ™ .
Be sure to check all pieces upon arrival for any damages that may have occurred during shipping
Panel C
Panel A
Panel B
26.5”
16”
26.5”
8”
16”
14.5”
16”
26.5”
16”
26.5” 16”
17.5”
26.5”
16”
9.5”
Load Bearing
Top
Side
Load Bearing
Bottom
Small
AquaBlox ®
Large AquaBlox ®
Side
Side
Single Module Assembly
B
A
A
B
Step 1 Step 2
Step 3
B
B
A
A
A
A
A
A
A
B
Common Plate
Triple Module Assembly
AquaBlox ® Components
Double Module Assembly
Step 1: Evenly distribute and connect the small panels to one large panel. •
Step 2: Next, working from one end to the other, attach a second large panel on the opposite side of the first. •
Step 3: Once the top and bottom large panels are attached, complete the sides of the tank module. This is a • "single" AquaBlox ® .
To build a double unit (or larger), follow the directions above, connecting the small panels to large panel on the top of a built AquaBlox ® . Proceed with
the remaining panels to complete the stacked tank.
Completed AquaBlox
® modules should be staged as close to the installation area as possible.