Aquascape Under Water Koi Camera (81054) - Manual

Under Water Camera
The underwater camera contains Sony super HAD optics. The outer housing of the camera is made of high quality stainless
steel. If you plan on using the camera for diving, fishing, or at depths deeper than 10 feet /3 m we recommend not using the
camera for more than one hour at a time.
• Do not use alcohol, acids, polishing powder, detergents or any petroleum products to clean or protect finish.
• Do not attempt to dismantle or disassemble the camera as it will void the warranty.
• Do not clean with hot water.
• Transformer and RCA cables must be connected and stored indoors.
Do not touch the lens directly, fingerprints will cause a blurry image and prevent proper focus.
Technical Specifications
Resolution 520 TVL
Effective Pixels NTSC:786(H)X 492(V)
CCD Image Sensor 1/3 Sony super HAD
Lens 3.6 mm MTV lens
Lighting Eight pieces white LED 3 mm / Dimmable with
Visible Distance 5m/ 15 feet
Waterproof Class IP68
White Balance Auto
Power Supply DC 12 V +/ -10%
Power Consumption 130 mA
Power Cord Length 10m/ 30 feet
Input Female RCA with male RCA adapter
Power Supply DC 12 V 1000 mA for inside use only
Operating Temperature -10° C - 50° C
Storage Temperature -10° C - 60° C
Product Warranty One year from date of purchase
Instructions for use:
1. Lift the camera from the box, peel off the lens protector and place into the desired location in the pond using small rocks to
position and secure the camera.
2. Connect the yellow RCA cable coming from the camera to the RCA input on your TV or monitor.
3. Connect the red female connection coming from the camera to the included indoor power supply (please note that the
power supply must be kept indoors).
4. Plug in the power supply.
5. Turn on the power to the TV or monitor selecting the appropriate input. You should be able to see an image on the monitor.
Please note: In clear water you should be able to view most objects in regular daylight.
However as your camera goes deeper underwater or when being used at night, there will be less light available and the
camera’s light sources will be needed to view the objects more clearly.
In some conditions of highly dirty or milky water, it may be impossible to view any object clearly, even with lighting. This is
simply because there are too many obstructions in the camera’s sight, not because of a malfunction of the camera.
The camera comes with 8 light emitting diodes (LED’s) the brightness of the LED’s can be adjusted with the rheostat located on
the cord just above the red and yellow connection.