APG PT-503 Slave Submersible Modbus user manual - Manual (Page 4)

PT-500 Submersible Pressure Sensor Rev. A, 5/13
4
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
• Installa on
The PT-500 should be installed in an area that meets the following condi ons:
• The temperature at the sensor does not exceed -40 o C to 85 o C (-40 o F to
+185 o F)
• Moun ng loca on is away from strong magne c fi elds, such as those
produced by motors, transformers, solenoid valves, etc.
• No corrosive chemicals of gasses that will a ack the sensor housing.
Cau on!
Do not bend sharply or kink the sensor’s cable. Crushing or otherwise ob-
struc ng the internal vent tube will result in errant readings. When suspending
the PT-500 by its cable, ensure that the cable clamp does not crush the vent
tube!
Do not kink or crush cable vent tube!!!