APG PG5 user manual - Manual (Page 6)

PG5 Rev. A1, 3/10
6
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Accessing the Mode Setting:
Step 1: Simultaneously press and hold the On/Off button and the (S) button
for approximately 3 seconds. This will bring up the 3 digit mode
number.
Step 2: Enter the desired mode number (see mode definitions below)
by using (Z) to change the value of the flashing digit, and (S) to
advance to the next digit.
Mode Definitions:
Mode 000: Full Access
- Provides access to all menu settings. If no buttons are pushed for 1
minute, the gauge will revert back to Mode 003 (factory default).
Mode 002: Limited Access
- Menu is locked
- (Z) button zeros the reading
- (S) cycles between the Max and Min readings
- On/Off functions only on battery powered gauges
Mode 003: Factory Default
- Full access except Full Scale Calibration is locked
Mode 005: Locked Access
- All buttons locked except the on/off button on battery powered
gauges.