Wiring the pg5 – APG PG5 user manual User Manual

Page 21

Text mode
Original mode

Rev. A1, 3/10

PG5

Automation Products Group, Inc.

APG...Providing tailored solutions for measurement applications

Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]

Wiring the PG5

Externally Powered, No Output:

Externally powered gauges without an analog output are powered using an 1/8
inch stereo jack connector (mate supplied) on the back of the gauge. The “Tip”
connection is “+ Power” and the “Center” connection is “- Power”.

Battery Replacement:

The battery is accessed by removing the single screw at the top of the battery
cover on the back of the gauge.

NOTE:

Do not overtighten the screw when securing the battery cover.

WARNING:

Always turn off the supply power before inserting or removing the

stereo jack plug. Failure to do so can damage the gauge.

NOTE:

Do not connect to the stereo jack’s case connection.

Supply