Anchor F3 FRAME TENT - Manual (Page 9)

9
STEP 6 Installation of hip end fabric
STEP 7 Installation of mid fabric
Figure 6
Figure 7
Unroll hip fabric and lay loosely beside frame, right side up.
Connect snap of pull rope to ring at end of kedar. Feed kedar up
into channel a few inches, then pull fabric up and over through
channel in rafter extrusion using the pull rope. One installer
should watch as kedar is fed into channel, while another should
keep hands on fabric as it is pulled over frame to ensure that
fabric does not catch on frame.
When fabric is centered on hip, move on to install the mid or
other end.
Unroll mid fabric and lay loosely
beside frame, right side up.
Connect snap of pull ropes to
rings at ends of kedars. Feed
kedar up into channel, then pull
up and over through channels in
rafter extrusions using the pull
ropes. One installer should watch
as kedar is fed into each channel.
When fabric is centered on frame,
move on to install rest of fabric.