Anchor F3 FRAME TENT - Manual (Page 11)

11
STEP 9 Tension fabric to frame - cont’d
STEP 10 Stake and Guy tent
Figure 10
2’-0”
Important Note:
Guys must be staked out at
2’-0” from uprights as shown.
Stakes are all 1” x 30”.
(1) stake required per
base plate. Snap one guy to each U bolt
on weldments. Corners are
staked out at 45° as shown.
Figure 9b
1
2
3
4
7
9
8
5
6
Start tensioning web straps to full
tension in the order shown by the
numbers.
Tension first (2) Corners and then go
to point 3.
Corners must be equally tensioned so
that punch slot in fabric is centered
on U-bolt in Weldment. Check that all
tension points look level across end
of tent. Watch for wrinkles in fabric
radiating out from tension points. This
may signal that tension is too tight or
unbalanced. Fabric should be smooth.
After corners are tensioned, proceed
to mid tensioning points.
Check that all tension points look level
across the side. Again, watch for
wrinkles.
Installation Cross Web (on 30’
model) may be removed after
fabric is installed. Reinstall at
time of take-down.