Anchor F3 FRAME TENT - Manual (Page 10)

10
STEP 8 Raise one side with Frame Lifts
STEP 9 Tension fabric to frame
Place frame lifts as shown and
attach to eave purlins.
Attach uprights to base plates.
Attach uprights to weldments on one side once
the side is raised to the appropriate height.
When one side has all uprights attached, move
frame lifts to the other side, and raise frame until
the end uprights can be attached.
After these uprights are installed, frame may
need to be lowered slightly so that the final side
can have uprights attached.
Tension tent to frame as shown at
right. Run ring of tension strap up thru
both rings of top then back down to
attach to hook on strap. Other end of
strap is hooked into slot provided in
upright.
Go all around the tent and tension all
straps to only snug tightness using
ratchet on strap.
Finish tensioning tent as shown in
figure 9b.
Figure 8
Kedar
Eave Line
Rafter
Ratchet
Upright
Figure 9