Anchor NAVI-TRAC LITE 30 WIDE - Manual (Page 13)

13
INSTALLING THE MID PANELS
To install the mid panel, first attach Fabric Guide Brackets to both beams of the middle bay with the guide wheel assemblies of
the two brackets facing toward each other (fig. 41).
Throw the snap ends of (2) pull ropes up and over the frame from one side of the tent to the other, so that the snaps hang near
the Fabric Guide Brackets.
Feed the leading edge of each Middle Panel kedar through the gap in the guide wheels on each side of the Middle Panel and
snap the pull rings to the pull web (See diagram at bottom of previous page & fig.41 & 42). As the panel is pulled, the kedar will
feed itself if the fabric bundle is free of tangles (fig. 43).
KEDAR CAPTURED IN
WHEELED GUIDES
CLOSE UP OF
GUIDE BRACKETS
PULLING KEDARS
THROUGH CHANNELS
41 42 43