American Lighting PLR-NF Series - Manual (Page 2)

1. Determine the required length for flexible light.
2. Cut the Polar Neon squarely at the nearest series increment cut
mark using a sharp rope light cutting tool or shears.
NOTE: Polar Neon is wired in series parallel. Cutting anywhere
other than the end/beginning of a series increment will result in a loss
of light. (see Figure 2)
3. Holding the smooth pins of the power pin with a pair of pliers, line up
the barbed pins with the two wires of the flexible light. Push barbed pins
into Polar Neon until flush, being sure to make solid contact with the
flexible light’s internal wires. (see Figure 3).
4. Slide the shrink tube over the assembly and onto the Neon Polar Neon.
5. Push the power cord sheath onto the assembly until fully seated.
6. Slide the heat shrink tube over the power cord sheath so that it is
centered over the junction of the Polar Neon and the power
cord sheath. (see Figure 4).
7. Attach end cap to other end of flexible light to cover exposed dead end.
CONNECTING POWER CONNECTION KIT (See Figures 2, 3, and 4)
NOTE: Do not exceed 150.9’ maximum run distance in any single run.
MOUNTING:
1. Make mounting clips using cut pieces of track (PLR-NF-TRACK-4, sold separately) or for straight line
applications, use PLR-NF-TRACK-4 mounting track; or use a combination of methods. PLR-NF-CHAN-1M
aluminum channel is also available (sold separately).
2. Make sure that the distance between any two parallel runs of lighting are at least 1/2” apart.
3. Gently press flexible light into track or clips so that it snaps into place.
PROP 65 WARNING:
Handling the coated electrical wires of this product exposes you to lead, a chemical known to the State of
California to cause cancer, birth defects, and other reproductive harm. Wash hands after use.
RV1433 WWW.AMERICANLIGHTING.COM
Polar Neon, Bulk Reels
Installation instructions for PLR-NF Series
10-10 AMERICAN LIGHTING
120V, 60
HZ MAX
LENGTH
150.9
FT.
Figure 2
Figure 3
Figure 4
Polar Neon
Power cord sheath
Heat shrink tube
Polar Neon and
power pin assembly
Power pin
Series increments are marked on
the side of the housing as shown.
Line up the barbed ends of the
power pin with the wires inside and
push pin in to make solid contact.
Trim off any wires that protrude from the
Polar Neon to prevent a short.