beautypg.com

Led rope light, bulk reel – American Lighting LED-MRL-XX-150 User Manual

Page 2

background image

WARNING:

Risk of fire. Do not replace attachment plug! Plug contains a safety feature (fuses) that

should not be removed. Discard cord set if the attachment plug is damaged.

CUTTING ROPE LIGHT (see Figure 2)
NOTE: Do not exceed 150 foot maximum run distance in any single run!

1. Determine the required length for LED Rope Light.
2. Cut the Rope Light at the end/beginning of the nearest series
increment. NOTE: Rope Light is wired in series parallel. Cutting
anywhere other than the end/beginning of a series increment
will result in a loss of 3 feet or 5 feet (total) of light. See Figure 2.
3. Attach power connector to cut Rope Light section per Figure 2.
4. Attach the plastic cap on the other end of the length of Rope
Light by pressing firmly until seated. For outdoor applications,
use dielectric grease inside the end cap before attaching and
seal the connection with heat shrink tube.

INSTALLING ROPE LIGHT
1. Attach mounting clips with nails or screws onto wooden surfaces.
Be sure that surface is mechanically sound. See Figure 4.
2. For best results, mounting clips should be evenly spaced and be
a maximum of 12” apart.
3. Make sure that the distance between two lines of Rope Light
are at least 1/2" apart.
4. Gently press rope light into clips so that it snaps into place.

PROP 65 WARINING

Handling the coated electrical wires of this product exposes you to lead, a
chemical known to the State of California to cause cancer, birth defects and
other reproductive harm.

WASH HANDS AFTER USE.

Figure 2

Figure 4

www.americanlighting.com

RV1309

AMERICAN LIGHTING

120VAC MAX 150FT

Cut marks are located

every 36” for Blue, Green,

White and Warm White;

and every 60” for Amber,

Red and Yellow.

Make sure power is off at source before cutting!

Installation instructions for LED-MRL-XX-150

LED Rope Light, Bulk Reel

Figure 3

Housing

Power

Connector

Rope Light

Retainer

Ring