American Lighting LR-LED Series - Manual (Page 2)

HOW TO EXTEND ROPELIGHT
NOTE: Do not exceed 192’ maximum run distance when interconnecting multiple LR-LED kits together.
1. Turn the plastic end cap counter-clockwise to remove from the first rope light.
2. Remove power cord from the second piece of rope light.
3. Connect both ends of the ropes (the male and female halves plug into each other). Make sure all
connectors are firmly tightened and secured. See Figure 2.
4. Repeat steps 1, 2 and 3 for any additional kits.
5. Turn the plastic end cap clockwise until it is firmly tightened and secured on the last rope light.
HOW TO INSTALL ROPE LIGHT
1. Attach mounting clips with nails or screws onto wooden surfaces. Be sure that the mounting surface is
mechanically sound. See Figure 3.
2. Mounting clips should be evenly spaced and be a maximum of 12” apart.
3. Make sure that the distance between two separate/nearby lines of LED Rope Light are at least 1/2" apart.
4. Gently press Rope Light into clips so that it snaps into place.
PROP 65 WARNING
Handling the coated electrical wires of this product exposes you to lead, a chemical known to the State of
California to cause cancer, birth defects and other reproductive harm.
Wash hands after use.
RV1414
LED Rope Light Kit
Installation intructions for LR-LED Series
Figure 3
Attaching mounting clips
Interconnecting Sections: Connect male and female halves together
and firmly tighten and secured.
Figure 2