Led chasing rope light – American Lighting LED-DLCH Series User Manual

Page 2

CUTTING ROPE LIGHT (see Figure 1)

NOTE: Do not exceed 150 foot maximum run distance in any single run.

1. Determine the required length for Rope Light.
2. Cut the Rope Light at the end/beginning of the nearest series
increment. NOTE: Rope Light is wired in series parallel and
every 72” (for Amber, Red and Yellow) or every 120“ (for Blue,
Green, White and Warm White) comprises a series increment.
Cutting anywhere other than the end/beginning of a series
increment will result in a loss of 72” or 120” (total) of light.
See Figure 1.
4. Attach the plastic cap on the other end of the length of Rope
Light by pressing firmly until seated. For outdoor applications,
use silicon or other waterproof adhesive inside the end cap before
attaching. Seal the end cap onto the end with heat shrink tube.

INSTALLING ROPE LIGHT
1. Attach mounting clips with nails or screws onto wooden surfaces. Be sure that surface is mechanically

sound. See Figure 2.

2. For best results, mounting clips should be evenly spaced and
be a maximum of 12 inches apart. However, for straight line
applications, use DL-TRACK-4.
3. Make sure that the distance between two lines of lighting
chains are at least 1/2" apart.
4. Gently press rope light into track or clips so that it snaps
into place.

CHASING ROPE LIGHT CONTROLLERS
Chasing Rope Light requires a chasing controller in order to
have chasing effects. Refer to manufacturer’s instruction sheet
for details.

PROP 65 WARNING
Handling the coated electrical wires of this product exposes you to lead, a chemical known to the State of
California to cause cancer, birth defects and other reproductive harm.

WASH HANDS AFTER USE.

Figure 2

Figure 1

www.americanlighting.com

RV-1302

Cut marks are located every
72” or 120”. Make sure
power is off at source
before cutting!

AMERICAN LIGHTING 1311

MERICAN LIGHTING 1311

120VAC CHASE MAX 150FT

20VAC CHASE MAX 150FT

LED Chasing Rope Light

Safety instructions for LED-DLCH Series