Led thirty puck light – American Lighting LP30 Series User Manual
Page 2
LED Thirty Puck Light
Installation intructions for models LP30 Series
RECESSED MOUNT
Terminal Block
Wire Drawing
From Transformer
www.americanlighting.com
RV1103-KB
RECESSED MOUNTING
1. Remove surface ring from LED light housing and discard. See Step 1 in SURFACE MOUNTING
on reverse side.
2. Drill a 1¾" hole in desired location.
3. Feed wires through the hole and press the fixture into the cabinet
until the springs lock against the back side of the surface.
4. Repeat steps 1 to 3 for any remaining lights.
5. FOR TWO, THREE OR MORE PUCKS:
See Terminal Block Wiring Diagram and follow steps 9 - 11 from Surface Mounting
instructions (on reverse)
POWER SUPPLIES
A plug-in 6 watt power supply is included with each kit, for use
with up to three LED Thirty Puck Lights only. For more than three,
use LED-DR-12 (sold separately), for up to sixteen LED Thirty Pucks.
ACCESSORIES
Optional Trim Rings (sold separately) can be used with
recessed LED Thirty Puck Lights. Simply press trim ring
onto outer edge of puck until it snaps into place.
Housing
1-3/4” cut-out
for recessed
mounting
From Pucks