American Lighting LVP Series - Manual (Page 2)

LED Puck Light Installation Instructions
Installation instructions for LVP Series (continued from reverse)
POWER CONNECTION:
1. Determine best location for the power connection hub with attached dimmer, considering that the
five foot lead wire from each puck will need to reach to a port. See Figure 3.
2. Install the power hub connection using the mounting screws included. Route each of the lead wires
from the puck lights to an available port.
3. Connect the power supply’s connector to the power connection hub as shown in Figure 3 below and
plug in power supply to a 120V AC wall outlet (receptacle).
brightness
adjustment
dial (0-100%)
WARNING! Risk of shock. Disconnect power to the unit before installing.
1. By combining a 5-pack set of puck lights and a single puck, you can create a set of six puck lights. This
is the maximum number of pucks that can be connected to one power supply. Do not exceed the
maximum.
2. Do not attempt to remove or change the LEDs in these fixtures.
3. Do not route wires through walls, floors or ceilings.
4. Route cords so they will not be pinched or damaged.
5. Do not alter plugs or connectors.
6. Not intended for recessed installation inside enclosed cabinetry (cabinetry that is not open at the top).
ADDITIONAL SAFETY MEASURES:
1. Use only insulated staples or plastic ties to secure cords.
2. Not intended for recessed installation in ceilings or soffits.
3. LEDs are bright! Do not look directly at lighted fixture.
4. Keep lamp away from curtains, draperies and similar flammable materials.
5. LEDs are not serviceable. Do not attempt to open or service LEDs or LED housing.
6. For indoor use only.
IMPORTANT SAFETY INSTRUCTIONS:
This product has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock.
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do
not alter the plug.
RV-1230 www.americanlighting.com
Figure 3
Power connection hub
with attached dimmer
Power supply