American Lighting EP4 Series - Manual (Page 2)

CAUTION: Always make sure power to the fixture is disconnected before beginning removal of
existing lamp and/or trim, or before beginning retrofit installation. Failure to do so can cause
electric shock, which can result in injury or death.
RETROFIT INSTALLATION
1. Confirm the LED trim is compatible with the recessed housing as outlined on reverse.
2. Remove existing lamp from existing recessed housing.
3. Remove existing trim from existing recessed housing.
4. Detach E26 socket adaptor from LED fixture by grasping plastic connectors firmly
and pulling apart. Do not grasp wires to pull connectors apart. See Figure 2.
5. Screw E26 socket adaptor into existing E26 socket at the back of the housing; or push
and twist GU24 socket adaptor into existing GU24 socket at back of housing. See Figure 3.
6. Insert male connector pins into female connector and press firmly together until fully
seated. See Figure 4.
7. Anchor fixture to recessed can, aligning torsion clips with interior wall of can. See Figure 5.
Figure 2
Figure 4
Recessed
housing
Ceiling
Ceiling
Figure 3
Insert male connector pins
into female connector and
press firmly until fully seated NEW CONSTRUCTION INSTALLATION
Follow step 1, then steps 4-7 above.
Figure 5
E26 or GU24
socket adaptor
Torsion clips
Recessed
housing
Installation instructions for EP4 Series
4” E-Pro LED Recessed Downlight
EP4 Installed
Ceiling
www.americanlighting.com
©2012 American Lighting, Inc.
Denver, CO 80231
RV-1333
Page 2 of 2