American Lighting EP6 - Manual (Page 2)

; an E26 adaptor; an insul
Installation instructions for EP6 and EP6H Series
CAUTION: Always make sure power to the fixture is disconnected before beginning removal of
existing lamp and/or trim, or before beginning retrofit installation. Failure to do so can cause
electric shock, which can result in injury or death.
RETROFIT INSTALLATION
1. Confirm the LED trim is compatible with the recessed housing as outlined on reverse.
2. Remove existing lamp from existing recessed housing.
3. Remove existing trim from existing recessed housing.
4. Detach E26 socket adaptor from LED fixture by grasping plastic connectors firmly
and pulling apart. Do not grasp wires to pull connectors apart. See Figure 2.
5. Screw E26 socket adaptor into existing E26 socket at the back of the housing; or push
and twist GU24 socket adapter into existing GU24 socket at back of housing. See Figure 3.
6. Insert male connector pins into female connector and press firmly together until fully
seated. See Figure 4.
7. Insert trim torsion springs into corresponding retaining brackets inside housing.*
Carefully push fixture gently to ceiling until seated. See Figure 5.
Figure 2
Figure 4 Figure 3
NEW CONSTRUCTION INSTALLATION
Follow steps 1, then 4-7 above.
6” E-Pro Series LED Recessed Downlight
Figure 5
*If housing does not have retaining
brackets (aka ”bullhorns”), attach
optional torsion clips using three
available trim ring retaining screws.
Recessed can
Ceiling
E26 or GU24
socket adaptor
Recessed can
Ceiling
Insert male connector
pins into female
connector and press
firmly together until
fully seated
Torsion springs
Inside recessed
housing
2012 Denver, CO 80231 • www.americanlighting.com © American Lighting, Inc. RV1333 Page 2 of 2