American Lighting A56-E26 Series User Manual

Page 3

INSTALLATION OF 5” & 6“ RETROFIT RECESSED LIGHT INTO RECESSED CANS - CONTINUED

FROM PREVIOUS PAGE
7. Plug the retrofit fixture’s plastic connector into the plastic connector of the Edison base (E26) socket adaptor.
See Figure 5.

5-YEAR LIMITED LIMITED PRODUCT WARRANTY

This product is warranted to be free from defects in material and workmanship for a period of five years from

the date of purchase.
Products that prove to be defective during this period will be either repaired (i.e. replacement of defective

electronics, defective parts of the fixture housing, lens, wiring, switching or lamp sockets; excluding the lamp)

or replaced, at the discretion of American Lighting, Inc. Claims for defective products must be submitted to the

retail location from which the product was purchased within the warranty period. Upon submission of proper

return claim documentation and product to American Lighting, Inc by the retailer, American Lighting, Inc

reserves the right to inspect the product for misuse or abuse. Claims for indirect or consequential damages or

for product that, in American Lighting Inc's opinion has been misused will be denied. This is a warranty of

product reliability only and not a warranty of merchantability or fitness for a particular purpose. American

Lighting, Inc shall have no liability whatsoever in any event for payment of incidental or consequential dam-

ages, including, without limitations, installation costs and damages for personal injury and property. These

products may represent a possible shock or fire hazard if improperly installed or altered in any way. This

warranty applies only to product that has been properly installed in accordance with instruction sheet and

current local codes and/or the National Electrical Code. Warranty does not apply to any product that has been

improperly installed or in situations where components have been altered in any way.

This warranty: (1) excludes expendable parts including but not limited to light bulbs, batteries; (2) carries a 2-year finish

warranty protecting finish against tarnishing, flaking, and discoloration; (3) shall be void if this lighting fixture is not

installed in the U.S.A; and (4) does not cover any losses, labor, injuries to persons/property or costs. This warranty does

give you specific legal rights and you may have other rights, which vary from state to state. Be careful, it is recom-

mended that installation be done by a qualified professional; the purchaser has sole responsibility for proper installation

in compliance with all state and local code requirements. Seller’s employees are not qualified to advise you on the use of

this Merchandise. Any oral representation(s) made will not be binding on seller or its employees. The rights under this

limited warranty are to the original purchaser of the Merchandise and may not be transferred to any subsequent owner.

This limited warranty is in lieu of all warranties, expressed or implied including warranties or merchantability and fitness

for a particular purpose. Seller shall not be liable for any special, incidental, or consequential damages. The sole

exclusive remedy against the seller will be for the replacement of any defects as provided herein, as long as the seller is

willing or able to replace this product or is willing to refund the purchase price as provided above.
For questions / comments, technical assistance or repair parts –

Please call toll free at: 1-800-285-8051 (M-F 8am – 5pm, CST)

Figure 5

A56 Downlight Installed

Recessed

housing

Ceiling

E26

socket adaptor

8. Squeeze the fixture’s torsion springs together

(one on each side) and install into torsion
spring receiving clips inside recessed housing.
See Figure 5.

9. Carefully route wires into housing and push

retrofit fixture up flush to ceiling surface.

REMOVING 5” & 6“ RETROFIT RECESSED LIGHT
1. With fingertips, pull down firmly on trim ring

until retrofit fixture lowers from ceiling and
stops.

2. Squeeze torsion springs together to remove

LED module.

3. Disconnect LED module wiring from recessed

housing by unplugging plastic connectors and
removing Edision (E26) socket adaptor.

LED Retrofit Recessed Downlight for 5” & 6” Housings

Installation instructions for A56-E26 Series

RV1352 Page 3 of 3