Led retrofit recessed downlight for 4” housings – American Lighting A4-E26 Series User Manual

Page 2

CONTINUED ON NEXT PAGE

CAUTION: Always make sure power to the fixture is disconnected before beginning removal of
existing lamp and/or trim, or before beginning retrofit installation. Failure to do so can cause
electric shock, which can result in injury or death.

COMPATIBLE HOUSINGS

This retrofit recessed light kit will work with most 4” housings (recessed cans). It has a built-in trim and does not

require any additional trim. Use in recessed housing with no open holes.

This retrofit recessed light is intended for installing in the field in recessed type IC luminaries with dimensions

outlined as follows: minimum height for 4” cans is 5-1/2” (14cm).

Suitable for wet locations in covered ceiling mount luminaries. The retrofit kit is accepted as a component of a

luminary where the suitability of the combination shall be determined by CSA or authorities having jurisdiction.

INSTALLATION OF 4“ RETROFIT RECESSED LIGHT INTO RECESSED CANS
1. Confirm the LED trim is compatible with the 4“ recessed housing as outlined above.
2. Remove socket mounting bracket and plate from inside existing recessed housing (if installed).
3. Remove socket from plate and discard plates.
4. Screw Edison base (E26) socket adaptor into back of recessed housing. See Figure 2.
5. Plug the retrofit fixture’s plastic connector into the plastic connector of the Edison base (E26) socket
adaptor. See Figure 3.
6. Carefully route wires into housing and push retrofit fixture up flush to ceiling surface. See Figure 3.

Recessed

housing

Ceiling

Edison (E26)

socket adaptor

Figure 2

Figure 3

REMOVING 4“ RETROFIT RECESSED LIGHT
1. With fingertips, pull down firmly on trim ring until retrofit fixture

lowers from ceiling and stops.

2. Pull down carefully r to remove LED module.
3. Disconnect LED module wiring from recessed housing by unplugging

plastic connectors and removing Edison (E26) socket adaptor.

CONTINUED ON

LED Retrofit Recessed Downlight for 4” Housings

Installation instructions for A4-E26 Series

RV1352 Page 2 of 3