American Lighting X45 Series - Manual (Page 2)

Interchangeable Series LED Recessed Downlight
Twist the baffle/multiplier into the trim piece. Push trim assembly up into light module and rotate baffle/multiplier
to the right until it stops (about 30-45 degrees clockwise) to lock trim assembly into place. See Figure 3.
When assembled the combined parts should look like Figure 4.
CAUTION: Always make sure power to the fixture is disconnected before beginning removal of
existing lamp and/or trim, or before beginning retrofit installation. Failure to do so can cause
electric shock, which can result in injury or death.
RETROFIT INSTALLATION
1. Confirm the LED trim is compatible with the recessed housing as outlined on reverse.
2. Remove existing lamp from existing recessed housing.
3. Remove existing trim from existing recessed housing.
4. Detach E26 socket adaptor from LED fixture by grasping plastic connectors firmly and pulling apart. Do not grasp
wires to pull connectors apart. See Figure 5.
5. Screw E26 socket adaptor into existing E26 socket at the back of the housing; or push and twist GU24 socket adaptor
into existing GU24 socket at back of housing. See Figure 6.
6. Insert male connector pins into female connector and press firmly together until fully seated. See Figure 7.
7. For X5-aaa-bb-X45 trim kit assemblies: insert trim torsion springs into corresponding retaining brackets in recessed
housing. Carefully push fixture gently to ceiling until seated. See Figure 8.
For
X4-aaa-bb-X45 trim kit assemblies: push fixture gently to ceiling
letting spring clips hold the assembly in place. If needed, bend out the
spring clips so they push against the housing wall for added retention.
Figure 5
Figure 7
Recessed
housing
Ceiling
Ceiling
Figure 6
Insert male connector pins
into female connector and
press firmly until fully seated
NEW CONSTRUCTION INSTALLATION
Follow step 1, then steps 4-7 above.
Figure 8
Inside recessed
housing
2013 Denver, CO 80231 • www.americanlighting.com © American Lighting, Inc. RV1351 Page 2 of 3
E26 or GU24
socket adaptor
Torsion
springs
Recessed
housing
Installation instructions for X45 Series (4”/5” adjustable retrofit)
Light
module
Figure 3
Trim
Baffle/
multiplier
ASSEMBLY DIAGRAM
THE ASSEMBLED X45 DOWNLIGHT IS NOW READY FOR USE WITH A 4” or 5” RECESSED HOUSING.
Figure 4