Allen&Heath DP 1000 USER GUIDE - Manual (Page 35)

10. S
ET THE
A
MPLIFIER
M
ODE
Decide which of the console mix busses is to be
configured to the
A and B outputs. These route to the
built in amplifiers ( DP1000) or to XLR outputs
( DL1000) to feed external amplifiers. The current
mode is displayed between the meters.
M FB
AUX FB
L R
Press the MODE key. Press the WX keys to scroll
through the three options. Press the flashing ENTER
key to accept the change, UNDO to escape. Press
RESET to restore the default LR setting.
To avoid unexpected changes in volume
make sure the amplifier level controls are turned
down before changing the mode.
11. S ET UP THE M ONITOR M IX
Set up an independent mix to send to the foldback
monitor speaker. Press the
FB key to display the level
from each channel. You can also send the effects so
that you can add the required amount of reverb to the
monitor mix. The sends are pre fader so that the
monitor level is not affected by the channel fader.
The soft strip becomes the foldback send controls,
one for each channel. The normal operating level is
0dB but 6dB of gain is available if required. Press
RESET to turn all the sends off. Press UNDO to restore
the last settings or those marked by pressing
ENTER.
Press AUX to display the level sent to the independent
auxiliary output. This is similar to the foldback mix
but can be switched globally pre or post fader. Use
the pre fader setting when you require an additional
monitor. Use post fader when you require an
additional effects or recording mix.
12. W
ORK WITH THE MEMORIES
RECALL SONG, VENUE and SET sequence memories
from the
HOME screen when performing live. The
current song number and name are displayed in large
characters and the venue and set names in small
characters.
Stereo PA left and right speakers
Mono PA with foldback monitor
External PA, 2 monitors
The soft strip controls become selectors to scroll
through the memories. The
ST keys duplicate
control 10 to let you step through the song memories
in incremental order. The
WX keys duplicate
control 1 to let you step through the song memories
in the order in which they are programmed in the
selected set sequence. Press
ENTER or UNDO to
confirm or escape recall of the displayed memory.
You can STORE the console settings in memory.
The graphic EQ and output mode settings are stored
in venue memories. The other parameters including
EQ, dynamics, effects, mix and channel mutes are
stored in song memories.
The SONG and VENUE keys:
STORE TO Press ENTER to store the current mixer
settings to the displayed memory number. Use the
WX keys or soft strip control 10 (song) or 9 (venue)
to select a different memory number if required.
Note that this number becomes current after pressing
ENTER.
RECALL The memories can also be recalled within
the
SONG or VENUE screens. Use the WX keys or
soft strip control 10 (song) or 9 (venue) to select a
different memory number if required. To recall the
same number press X once first.
COPY Press COPY while in the STORE or
RECALL screen. This copies the current song or
venue settings to the copy buffer. The
PASTE key
lights to show that valid data is available in the
buffer.
icon
SERIES
5 - 5