AirLive WN-300PCI - Manual (Page 56)

52
Beacon(ms) You can define the time interval that a beacon signal should be
send. Default value is 100. Do not modify this value unless you
know what will be affected.
TX Power You can select the wireless output power here. Please select a
proper output power setting according to your actual needs. You
may not need 100% of output power if other wireless clients are
not far from you.
Idle Time Select the idle time for the wireless access point. Default value
is 300. Do not modify this value unless you know what will be
affected.
To save changes, click ‘Apply button. Or you can click ‘Default’ to reset all values to factory
default value.
3.2 Security Setting
This wireless card supports wireless encryption in AP mode, which will encrypt the data
being transferred over the air to enhance data security level. It’s recommended to enable
data encryption unless you wish to open your computer (and its internet connection) to the
public.
When you click ‘Security Setting’ in the utility, the following window will appear: