AirLive WN-300PCI - Manual (Page 14)

10
Please note that if you stopped config utility by ‘Exit’ function, you’ll not be able to maintain
the wireless link to the access point you wish to use. In this case, you can start config utility
again by clicking ‘Airlive Wireless Utility’ icon from ‘Start’ -> ‘All Programs’ -> ‘Airlive
Wireless’, as shown below.
2.2 Connect to Wireless Access Point
After the driver is correctly installed, it will try to connect to any unencrypted wireless
access point automatically. If you want to connect to a specific wireless access point, or the
access point you wish to connect uses encryption, you have to configure the wireless
network card and input required parameters, to get connected to the wireless access point
you wish to connect.
The current status of wireless connection will be displayed by Airlive configuration utility
icon:
NOTE: In Vista, the network card will not connect to any unencrypted wireless
access point automatically.