AirLive WN-300PCI - Manual (Page 27)

23
connecting to another computer using Ad Hoc mode), please
select Ad hoc here.
If you selected an access point from the list above, please
keep this field unchanged.
Tx Power You can select the wireless output power here. If you’re not
too far from access point (good signal reception), you can
select a lower output power to save energy; for a distant
access point, you can select a higher output power.
It’s suggested to select ‘Auto’ to let setup utility decide the
best output power for you.
Preamble Select the preamble for Ad hoc mode here. Available options
are ‘Auto’ and ‘Long’.
It’s suggested to select ‘Auto’ to let setup utility decide the
preamble for you.
Channel You can select the radio channel number for AdHoc mode
here.
Power Save
Mode Please select CAM (constantly awake mode, keep wireless
radio activity even when not transferring data), or PSM
(Power saving mode, switches radio off when not transferring
data).
It’s recommended to choose ‘PSM’ if you’re using this
network card with notebook computer to help the battery live
longer.
RTS Threshold Check this box to set the RTS threshold by yourself. You can
drag the slider to set the threshold value, or input the value in
the box located at right.
It’s recommended to keep this value untouched unless you
know the effect of changing this value.
Fragment
Threshold Check this box to set the packet fragment threshold by
yourself. You can drag the slider to set the threshold value, or
input the value in the box located at right.
It’s recommended to keep this value untouched unless you
know the effect of changing this value.