AirLive WL-5450AP - Manual (Page 25)

AirLive WL-5450AP User’s Manual
23
Reset Press to discard the data you have entered since last time you press Apply Change.
4.3.4 Access Control
When Enable Wireless Access Control is checked, only those clients whose wireless MAC addresses listed
in the access control list can access this Access Point. If the list contains no entries with this function being
enabled, then no clients will be able to access this Access Point.
Wireless Access
Control Mode
Select the Access Control Mode from the pull-down menu.
Disable: Select to disable Wireless Access Control Mode.
Allow Listed: Only the stations shown in the table can associate with the AP.
Deny Listed: Stations shown in the table won’t be able to associate with the AP.
MAC Address Enter the MAC Address of a station that is allowed to access this Access Point.
Comment You may enter up to 20 characters as a remark to the previous MAC Address.
Apply Changes Press to save the new settings on the screen.
Reset Press to discard the data you have entered since last time you press Apply Change.
Delete Selected To delete clients from access to this Access Point, you may firstly check the Select
checkbox next to the MAC address and Comments, and press Delete Selected.
Delete All To delete all the clients from access to this Access Point, just press Delete All
without selecting the checkbox.
Reset If you have made any selection, press Reset will clear all the select mark.