AirLive WL-5450AP - Manual (Page 13)

AirLive WL-5450AP User’s Manual
11
3.2 WDS Repeater Mode
Refer to the illustration below. While acting as Bridges, AP1 (with Station 1 being associated to) and AP2
(with Station 2 being associated) can communicate with each other through wireless interface (with WDS).
Thus Station 1 can communicate with Station 2 and both Station 1 and Station 2 are able to access the
Internet if only AP1 or AP2 has the Internet connection.
To set the operation mode to Bridge, please go to “Wireless JBasic Settings”, in the “Mode” field click the
down arrow b to select AP mode. And go to “Wireless JWDS Settings” to enable WDS.
Note:
To act as Bridge, both AP1 and AP2 must have WDS enabled and add each other as its WDS Access
Point. (e.g. Add AP2’s MAC address to AP1’s “WDS AP List” and vice versa)