AirLive WL-5450AP - Manual (Page 11)

AirLive WL-5450AP User’s Manual
9
Chapter II: Hardware Connection
Note: Before you starting hardware connection, you are advised to find an appropriate location to place the
Access Point. Usually, the best place for the Access Point is at the center of your wireless network, with line of
straight to all your wireless stations. Also, remember to adjust the antenna; usually the higher the antenna is
placed, the better will be the performance.
1. Connect to your local area network: connect a Ethernet cable to one of the Ethernet port (LAN1 or
LAN2) of this Wireless Access Point, and the other end to a hub, switch, router, or another wireless access
point.
2. Power on the device: connect the included AC power adapter to the Wireless Access Point’s power port
and the other end to a wall outlet.
3. Configure your PC: Make sure your local PC(s) has wireless network adapter installed.
2.1 Check the LEDs:
The Power and LAN # LEDs should be ON. LAN# LED will even blink if there is traffic.
The Link/Act LED will be on in static when associated with a station and blink whenever this AP receives data
packets in the air.
If the Status LED glows after self-test , it means this Wireless Access Point fails on self test. Please ask
your dealer for technical support.