AirLive VS-100 - Manual (Page 11)

2. Package Contents and Installation
AirLive VS-100 User’s Manual 8
12VDC-in Jack
The input power is 12VDC. Note that supply the power to the Video Server with standard
power adapter included in package. Otherwise, the improper power adapter may damage
the unit and result in danger.
Factory Default Reset
This button is hidden in the pinhole. This button is used to restore the all factory default
settings. Sometimes restarting the Video Server will make the system back to a normal
state. If the system still got problems after restart, user can restore the factory default
settings and install it again. To restore the device, please follow the steps below:
1. Insert the paper clip or other tool and press and hold the button down continuously.
2. Hold it at least 5 seconds and release the tool. Then the device has been restored to
default settings and reboot again.
Note: Restoring the factory default setting will lose the all previous settings included IP
address forever. User needs to run the IPWizard II program to search the device and
configure it to let the device work properly again.
Audio/Video Output Jack
Audio/Video-out Jack allows this device to output audio and video signal. Use the attached
A/V cable to connect A/V device where white cable is for audio and yellow cable is for
video.
„ 2.3 Hardware Installation
1. Attach video source to Video Server
To use this device, user must supply video source to this device first. Typical, user may
utilize box camera, doom camera, bullet camera, P/T/Z camera, Speed doom camera, or
others as the video source. Connect the BNC terminal of camera to the device’s video input
and make sure to power on these cameras first. Otherwise, the operation may be incorrect.