AirLive POE-280HD - Manual (Page 83)

7. Setting-Advanced
AirLive POE-280
Note: You can set alarm buffer at alarm buffer screen. (Please go “Setting →
Advanced → Alarm Buffer → Setting”)
z
Parameter: the parameter of CGI (defined in URL of HTTP → General) is from
your target device. For example, move=down.
z
Message: message will show up in the form of Message = PTZ down. If your
target device didn’t support the parameter of message, you can’t see the
message. So you can just take the message as a note. For example: PTZ down.
Effective Period:
Set the period when the periodical sending is effective.
z
Always: The periodical sending is always effective.
z
Schedule: You can specify the period when the periodical sending is effective in
the schedule setting in the other section.
Note: You can set schedule function at schedule screen. (Please go “Setting →
Advanced → Schedule → Setting”) For more details, you can check
7.6 Alarm output
You can set Alarm Output function in this menu to control the alarm out of I / O port on the
rear of the device linked to the alarm detection and the timer.
HD User’s Manual
78