AirLive BC-5010 User Manual
Page 15
2. Package Contents and Installation
AirLive BC-5010 User’s Manual
9
1. RJ45 LAN socket: Connect to PC or Hub/Switch.
For connections to 10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This
Ethernet port built N-Way protocol can detect or negotiate the transmission speed of the
network automatically. Please use Category 5 cable to connect the Network Camera to a
100Mbps Fast Ethernet network switch or hub.
In the LAN socket, there are two LEDs embedded:
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
Power (orange color)
This LED is used to indicate whether DC power is on or not. In addition, this LED will
be flashing while the wireless accessing of the Camera.
2. GPIO/RS-485: Connect to a local keyboard controller.
DI/ DO: Connect to sensor in and alarm out devices
Cable for I/O connectors:
PIN
SPECIFICATION
1 RS-485 D+
2 RS-485 D-
Compliant to RS-485
3 Ground (Common)
GND
4 GPIO Out
Close circuit current maximum: 70mA AC or
100mA
Output resistance: 30 ohm
Open circuit voltage maximum: 240V AC or
350V DC
5 GPIO In #1
6 GPIO In #2
Action high voltage: 9~40 VDC
Dropout voltage: 0 VDC
3. DC-in Jack: The input power is 12VDC.
Note that supply the power to the Network Camera with the power adapter included in
package.
4. Audio I/O Connectors