4x dvl port, 4x bri port – 2N NetStar Hardware manual User Manual

Page 34

Text mode
Original mode

NT without power supply

Connect pins 1–2, 3–4, 5–6, 7–8 and do not connect the power supply pins

Connect pins 1–3, 2–4, 5–7, 6–8 and do not connect the power supply pins

Attention
on the positions with the HW addresses 5, 9 and 13 the ports 0 and 1
always have the NT configuration.

4x DVL port

Interface type – Upn (NT–U), LAP–S with 48V power supply
Protocol – Cornet II
RJ45 Connection – two conductors, Pin4 and Pin5 = broadcasting/ reception

4x BRI port

Interface type

S0 (NT–S/T, LT–T ) with phantom power supply –42V
S0 (TE–S/T, LT–S ) without power supply

Protocol – DSS1 – EURO ISDN
Connection – RJ45 – four conductors
Pin3, Pin6 = broadcasting couple
Pin4, Pin5 = reception couple

Obj. no. 1011124 2N NETSTAR module 4x BRI/4x DVL