2N Omega Lite - Installation Manual v1.9 - Manual (Page 53)

53
7. Fasten down the expansion deck mechanics to chassis by two M3 screws
(attached in the set).
8. Interconnect both mechanic parts by earth-wire in the upper part of the
mechanics on the left side. Use attached earth-wire and two M3 screws.
9. Place the display into plastic „holders“ in the upper part of the expansion deck
mechanics and connect cabel to connector J17 on the basic module.
10. Mount on plastical cover for PbX 2N
®
Omega 48.
11. Upgrade software in the PbX to version PbX 2N
®
Omega 48.
12. See instructions in the instalation manual.