Echo 74624S Owners Manual v.2 - Manual (Page 26)

24
SERVICE & MAINTENANCE
beFoRe INSPeCtINg oR SeRvICINg aNy PaRt oF tHIS MaCHINe, SHut oFF PoWeR SouRCe,
dISeNgage tHe HydRaulICS, oPeN SHIeld aNd Make SuRe all MovINg PaRtS Have CoMe to a CoMPlete StoP.
Warning
5.7 chiPPer anvil
the four chipping blades should clear the chipper anvil
by 1/16 inch to 1/8 inch. The chipper anvil is adjustable
and reversible. all four sides of the anvil can be used for
chipping.
To adjust:
1. lift rotor access cover and expose rotor.
2. loosen the three 1/2 inch bolts that hold the chipper
anvil to the frame.
3. Measure the amount of clearance between chipping
blade and chipper anvil from inside of housing.
4. Adjust inward or outward to the desired measurement,
using the adjustment nuts provided.
5. tighten bolts on chipping block to 75 ft. lbs. and resume
operation.
If chipper anvil edge is damaged or worn unevenly, remove
the three bolts holding the anvil and use one of the other
three edges. Replace as necessary
Chipper anvil
5.8 air filTer (dieSel ShoWn)
Diesel Air Filter
both the kubota diesel and the Honda gas engines used
on the 6” chipper have air filters. Refer to the Kubota
and Honda engine manuals, included with your machine,
for specific instructions on replacing and cleaning these
filters.
5.9 coolanT (dieSel)
See your engine owner's manual.