Echo 74624S Owners Manual v.2 - Manual (Page 13)

11
ASSEMBLY
2.7 adding moTor oil To engine
the machine was shipped with oil in the engine, as it
was tested at the factory.
to determine which type of oil to use, refer to the
engine owners manual included in the owners kit of
the chipper.
Remove the oil fill plug.
Checking as necessary, add oil to the motor until the
dipstick shows the correct reading.
1.
2.
3.
4.
Hydraulic fluid drives the feed roller. The hydraulic pump
is direct or belt driven from the engine or disk rotor.
The hydraulic pump requires premium hydraulic fluids
containing high quality rust, oxidation, and foam inhibi-
tors. these include premium turbine oils, aPI Cd engine
oils per Sae J183, M2C33F or g automatic transmission
fluids meeting Allison C-3 or Caterpillar TO-2, and certain
specialty agricultural tractor fluids.
If system has no oil, follow this startup procedure:
Clean all system components (reservoir, fittings, etc.)
before starting the hydraulic pump.
after filtering the hydraulic fluid, fill the hydraulic res-
ervoir.
Fill the inlet line leading from the reservoir to the pump
before start-up. loosen the fitting at the pump on this
inlet line until oil bleeds out.
Start the engine and run at the lowest possible RPM.
as you purge air from the unit, the oil level in the res-
ervoir will drop and bubbles may appear in the fluid.
Refill the reservoir as necessary.
Run the feed roller in both directions for several min-
utes until any remaining air purges from the unit. Refill
the reservoir as necessary.
Shut down the engine, check for and correct any fluid
leaks, and check the reservoir level. add fluid if neces-
sary. the hydraulic pump is now ready for operation.
1.
2.
3.
4.
5.
6.
7.
2.6 checking/adding hYdraulic fluid
2.8 check coolanT (dieSel onlY)
you may need to add coolant before you start the diesel
engine. See engine owner's manual.
2.3 aTTach Trailer hiTch
attach the ball coupler to the hitch weldment using
the provided 1/2” x 4” bolts and 1/2” washers and 1/2”
nuts. tighten to proper torque.
Slide the hitch weldment into the hole in the frame,
back to the 1/2” mounting holes.
Connect the hitch weldment to the frame using the two
1/2” x 4-1/2” bolts, 1/2” washers and 1/2” nuts. tighten
to proper torque.
1.
2.
3.
2.4 rear STabilizer
the rear stabilizer is installed by sliding the stabilizer into
the corresponding slot on the rear of the chipper frame.
The stabilizer is secured and adjusted with the provided
snap pin.
2.5 check baTTerY
the chipper is shipped with a battery. the battery is
connected to the battery cables using the two 1/4” bolts
and nuts found in the parts kit. to connect:
Route the battery cables to the proper battery terminals,
hooking positive to positive, and negative to negative.
Connect cables with 1/4” bolt and nuts. tighten nuts
to proper torque.
Check battery for proper fluid level and fill if neces-
sary.
If necessary, charge battery.
1.
2.
3.
4.