Echo 74624S Owners Manual v.2 - Manual (Page 17)

15
OPERATION
4.2 STarTing a gaSoline chiPPer 4.3 STarTing a dieSel chiPPer
Make sure the cutting chamber is empty before starting.
Reference the Honda owners Manual.
Check engine oil level before starting. do not overfill
or underfill oil. the Honda engine is equipped with an
oil level sensor and will not allow the engine to start
in either condition.
Make sure the chipper engagement lever is in the
start position.
engage the choke if necessary.
Adjust throttle to start/idle position.
turn the key to the right to engage the starter.
Release the key after the engine starts.
For a Cold engine — gradually return the choke from
the choke position to the run position as the engine
warms up.
1.
2.
3.
4.
5.
6.
7.
8.
Handle fuel with care. It is highly flammable. Always use
an approved container and fill tank outdoors.
Move machine to a clear level area. do not operate in
the vicinity of bystanders.
Warning
noTe
Make sure the cutting chamber is empty before starting.
Reference the kubota owners Manual.
before starting, fill engine with oil to the correct level.
See engine manual for additional starting, operation
and maintenance instructions. Some oil usage is nor-
mal. Check level before each use.
Make sure the chipper engagement lever is in the
start position.
turn key switch to preheat position (to the left). Hold
in preheat position for several seconds until glow plug
indicator light switches off.
Place throttle control in the idle position.
Push in and hold the Murphy switch push-button. Con-
tinue to hold Murphy switch in when cranking engine
until engine is running.
activate the starter. Release the switch as soon as
the engine starts. do not crank over for more than 10
seconds. after engine is running; hold murphy switch
until engine has oil pressure.
1.
2.
3.
4.
5.
6.
7.
Move machine to a clear, level area. do not operate
in the vicinity of bystanders.
the Murphy switch system will shut the engine off if the
oil pressure is too low or if the engine temperature is
too high. If the engine will not run or shuts off for these
reasons, consult your local dealer.
allow the machine to come to complete stop before
inspection or servicing.
Warning
cauTion
noTe