Brother HE 120 - Manual (Page 36)

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
30
d
Thread the thread cassette with the thread
from the spool on the extra spool pin.
• For more details, refer to "Loading the spool
into the thread cassette" (page 24).
e
Check that the thread cassette indicator is lit
up in green, and insert the thread cassette
(with the extra spool pin attached) into the
thread cassette compartment.
Use both hands to press down on both sides of
the extra spool pin.
X At the same time that the thread cassette is
inserted, the needle is threaded.
X The extra spool pin is now installed.
Thread the needle manually
(without using the needle threader)
When using special thread, thread with a thickness of
130/20 or thicker, the wing needle or the twin needle
which cannot be used with the needle threader,
thread the needle as described below.
a
Remove the needle.
• Refer to "Replacing the needle" (page 37).
• When using the wing needle, the twin needle
or thread that cannot be used with the needle
threader, be sure to remove the needle,
otherwise the machine may be damaged.
b
Check that the thread cassette indicator is lit
up in green, and then insert the thread cassette
into the thread cassette compartment.
• For details, refer to
a
through
b
(page 27).
X Pass the thread through the needle bar
thread hooks.
a Needle bar thread hooks
c
Replace the needle.
• Refer to "Replacing the needle" (page 37).
d
Pass the thread through the eye of the needle
from front to back.
1
SE-BrotherE_sgml.book Page 30 Monday, June 30, 2003 3:44 PM