JLG X14JH Operator Manual - Manual (Page 57)

NOTE: it is important that when the machine is stabilized the undercarriage is ALWAYS lif‑
ted from the ground.
An improper stabilisation of the machine does not allow a proper working stability. The
Constructor forbids the use of the machine if not stabilised as prescribed in this manual. The
turning over of the machine can cause serious injuries or death to its occupants and ground
staff.
If one of the orange lights on each stabiliser does not flash even when the stabiliser is raised
from the ground, stop the machine immediately and call the customer service as this signals
the breakage of the micro‑switches of the relative stabiliser.
If working on the machine stabilised on slippery surfaces (marble, porphyry, smoothed con‑
crete, wet smooth surfaces etc.), check that the basket movements do not induce the moving
of the crawler. In this case, stop the operations and go back to the operating safety conditions
established by the manufacturer.
2.9.6 MOVING THE CONTROL CAR
Once the machine has been correctly stabilized it is possible to proceed with the motion of
the basket:
‑ Climb onto the basket alone with the tools necessary for the operations for an overall
load not exceeding 120kg;
‑ Position properly the machine;
‑ Stabilise the machine within the limits planned by the manufacturer according the pro‑
cedure described in this manual;
‑ Select option 120kg on the electric panel on the control car;
‑ Lift the third arm;
‑ Raise the pantograph composed of 1st and 2nd arm (to do so act on the lever which con‑
trols them automatically);
‑ Lengthen the withdraw;
‑ Lift the jib.
BOOM LIFT MODELS X14JH
JLG
54 X14JHR0220311
IMPORTANTE
PERICOLO
PERICOLO
PERICOLO
DANGER
DANGER
DANGER
IMPORTANT