JLG G12-55A AccuPlace Operator Manual - Manual (Page 94)

Section 5 - Attachments
5-26 3128447
Truss Boom
Use Appropriate Truss Boom Load Chart
To determine maximum capacity, refer to “Telehandler/
Attachment/Fork Capacity” on page 5-3.
Suspend loads in accordance with requirements set forth in Section
1 - General Safety Practices.
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The attachment tilt roller switch (2) controls truss boom tilt.
• Push roller switch down to tilt up.
• Push roller switch up to tilt down.
Winch Control (if equipped):
The auxiliary hydraulic joystick (3) controls the truss boom mounted winch.
• Move joystick right to raise cable.
• Move joystick left to lower cable.
Installation Procedure:
• Refer to “Attachment Installation” on page 5-10.
OAM1960
OY1381
1
3
2