JLG G12-55A AccuPlace Operator Manual - Manual (Page 116)

Section 7 - Lubrication and Maintenance
7-12 3128447
Engine Oil
A. Engine Oil Level Check
1. Perform “Shut-Down Procedure” on page 4-3.
2. Open the engine cover.
3. Remove dipstick (1) and check oil mark. The oil should be between the full (2)
and add (3) marks within the crosshatched area of the dipstick.
4. Replace dipstick.
5. If oil is low, remove oil fill cap (4) and add motor oil to bring oil up to the full mark
in the crosshatch area.
6. Replace oil fill cap.
7. Close and secure the engine cover.
Note: The standard service interval for engine oil and filter is 250 hours maximum.
If an extended service interval is desired, see your engine manual for specific
guidelines for optimizing oil change intervals.
10
OW0970
OW1020
OAL0820
4
1
3
2
ADD